Ford Mustang (1999-2004) Service Manual: Safety Belt Buckle - Rear Seat
Removal
1. Remove the rear seat cushion.
2. Remove the bolt and the safety belt buckle.
Installation
1. NOTE: LH and RH rear seat safety belt buckles have different anchor plates. Make sure correct part is used when installing buckle and anchor plate in the anchor locator feature.
NOTE: LH rear seat safety belt buckle anchor plate shown.
To install, reverse the removal procedure.
2. Make sure the safety belt buckles are routed correctly and are placed through the seat cushion.
3. Check the restraint system for correct operation.
Child Safety Seat Tether Anchor -LATCH
Removal and Installation
1. Remove the lower anchors and tethers for children (LATCH) attachment fasteners.
2. Remove the LATCH attachment.
3. To install, reverse the removal procedure.
Safety Belt Buckle - Front Seat
Removal Driver and passenger seat 1. Remove the front seat. For additional information, refer to Section. 2. Remove the nut and the safety belt buckle. Driver seat only 3. Disconnect the safety bel ...Supplemental Restraint System
Torque Specifications ...Other materials:
Drive Pinion Flange and Drive Pinion Seal
Special Tool(s)
2-Jaw Puller
205-D072 (D97L-4221-A) or
equivalent
Holding Fixture, Drive Pinion
Flange
205-126 (T78P-4851-A)
Installer, Drive Pinion Flange
205-002 (TOOL-4858-E) or
equivalent
...
Turn Signal and Hazard Lamps
Refer to Wiring Diagrams Cell 90 , Turn/Stop/Hazard Lamps for schematic
and connector information.
Special Tool(s)
73 III Automotive Meter
105-R0057 or equivalent
Inspection and Verification
1. Verify the customer concern.
2. Visually ins ...
Appendices
GENERAL INFORMATION
SYNC® End User License Agreement (EULA)
• You have acquired a device (“DEVICE”) that includes software
licensed by FORD MOTOR COMPANY from an affiliate of Microsoft
Corporation (“MS”). Those installed software products of MS orig ...