Ford Mustang (1999-2004) Service Manual: Seat Track
Removal and Installation
1. Remove the front seat. For additional information, refer to Seat-Front Power in this section.
2. Remove the outboard seat trim shield.
3. Disconnect the electrical connector.
4. Remove the seat track bolts.
5. To install, reverse the removal procedure.
Seat - Front Power
Removal and Installation 1. Remove the safety belt through the opening in the safety belt guide. 2. Move the seat forward. 3. Remove the bolt covers and remove the seat track bolts. 4. Move the ...Lumbar Motor
Removal and Installation All vehicles 1. Remove the front seat. For additional information, refer to Seat-Front Power in this section. 2. Disconnect the power seat track electrical connector. ...Other materials:
Pinpoint Test O: DTC B1870 - Air Bag Indicator Shorted to Battery
Normal Operation
The air bag indicator is designed to illuminate for 6 (+/-2) seconds
when the ignition switch is turned to
the RUN position. This initial 6 seconds of illumination is considered
normal operation and is called
proveout of the air ba ...
Engine Dynamic Balance Shaft
Removal
1. Remove the timing chain (6268). For additional information, refer to
Timing Chain in this
section.
2. Disconnect and position the wire harness aside.
3. Remove the radiator fan and shroud assembly (8146).
4. Remove the engine dynamic balan ...
Cooler - Fluid
Removal
1. Raise and support the vehicle.
2. Disconnect the power steering hoses.
3. Remove the bolt and routing bracket.
4. Remove the bolts and the power steering fluid cooler.
Installation
1. To install, reverse the removal procedure.
2. Fill and ...