Ford Mustang (1999-2004) Service Manual: Selector Lever
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the TCS connector.
6. CAUTION: Extra force may be needed to lift up on the handle. Do not to pull too far or damage to the overdrive cancel button may result, as the wires may be pulled out of the switch.
Remove the screw and the handle.
7. Raise and support the vehicle. For additional information, refer to Section.
8. Disconnect the shift cable and discard the plastic clip.
9. Lower the vehicle.
10. Remove the shifter.
Installation
1. NOTE: It is necessary to install a new plastic clip prior to installation.
To install, reverse the removal procedure.
Cable and Bracket
Removal 1. Raise the vehicle on a hoist. For additional information, refer to Section. 2. Remove the cable shift from the shifter lever and bracket and discard the clip. 3. Remove the bol ...Transmission Control Switch
Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the TCS connector. 6 ...Other materials:
Running out of fuel
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
• You may need to cycle the ignition from off to on several times after
refueling to allow the fuel system to pump the fuel fr ...
Supercharger Cooling System Draining, Filling and
Bleeding
Draining
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling system is hot. Failure to follow these instructions can result in damage
to the cooling
system or engine or personal injury. To avoid having scalding hot ...
Opening the convertible top
Note: Do not store articles behind rear seat. Articles stored in the
convertible top stowage compartment may break the rear glass window
when the top is opened.
Note: Opening the convertible top when the top material is wet may
cause mold or mildew.
The conv ...