Ford Mustang (1999-2004) Service Manual: Sensor - Front
Removal
1. Remove the wheel and tire assembly. 2. Remove the inner fender splash shield.
1. Remove the inner fender splash shield push pins.
2. Remove the inner fender splash shield screw.
3. Remove the inner fender splash shield.
3. Remove the front anti-lock brake sensor electrical connector.
4. Remove the front anti-lock brake sensor harness from the anti-lock brake sensor harness clips.
5. Remove the front anti-lock brake sensor.
1. Remove the front anti-lock brake sensor bolt.
2. Remove the anti-lock brake sensor harness from the harness clips.
3. Remove the front anti-lock brake sensor.
Installation
1. To install, reverse the removal procedure.
Module
Removal 1. Remove the hydraulic control unit (HCU). Refer to Hydraulic Control Unit . 2. Remove the pump motor electrical connector. 3. Remove the anti-lock-brake control module screws. 4. Remove th ...Other materials:
Cabin air filter
Note: Make sure you have a cabin air filter installed at all times.
This
prevents foreign objects from entering the system. Running the system
without a filter in place could result in degradation or damage to the
system.
Your vehicle is equipped with a cabi ...
Selector Lever
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the TCS connector.
6. CAUTION: Extra force may be needed to lift up on the handl ...
Pinpoint Tests
PINPOINT TEST P1464: DTC P1464: A/C DEMAND OUT OF SELFTEST
RANGE
Test Step
Result / Action to Take
P14641 RECHECK FOR THE DTC
YesGO to P14642 .
No
The system is functioning
correctly. This DTC will set if the
A/C is turned on when carryi ...