Ford Mustang (1999-2004) Service Manual: Sensor Indicator - Rear
Special Tool(s)
Pinion Bearing Cone Remover 205-D002 (D79P-4621A) | |
Axle Bearing/Seal Plate 205-090 (T75L-1165-B) | |
Sensing Ring Replacer 206-041 (T89P-20202-A) |
Removal
1. Remove the rear axle shaft bearing.
2. Using the special tool, remove the anti-lock brake sensor indicator from the axle shaft.
Installation
1. Using the special tools, align the rear anti-lock brake sensor indicator to the rear axle shaft.
2. Using the special tools, press the rear anti-lock brake sensor on the rear axle shaft to specification.
3. Install the rear axle shaft bearing.
Hydraulic Control Unit
Removal 1. Disconnect the battery ground cable(14301). 2. Disconnect the anti-lock-brake control module electrical connector. 3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction cont ...Other materials:
Powertrain/Drivetrain Mount Neutralizing
WARNING: The electrical power to the air suspension system must be shut
off prior to
hoisting, jacking or towing an air suspension vehicle. This can be accomplished
by turning off
the air suspension switch. Failure to do so can result in unexpected inflation ...
Fuel Vapor Control Tube Assembly Valve
Removal and Installation
1. Remove the fuel tank. For additional information, refer to
Section.
2. Remove the retainers.
3. NOTE: The fuel vapor vent valve, fuel vapor control valve and the
in-line fuel tank pressure
sensor are repaired as a fuel va ...
Switch - Speed Control Actuator
Removal
1. Remove the steering wheel; refer to Section.
2. Remove the steering wheel rear cover.
1. Remove the screws.
2. Remove the steering wheel rear cover.
3. Remove the ribbon harness from the clips.
4. Remove the horn contact electrical c ...