Ford Mustang (1999-2004) Service Manual: Shock Absorber
Removal
WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. Failure to follow these instructions can result in personal injury.
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
CAUTION: When using a hoist that lifts the vehicle by the frame, install new shock absorbers one at a time.
1. Open the luggage compartment lid. Position the carpet out of the way.
2. Remove and discard the retaining nut, washer and insulator assembly.
3. Raise the vehicle.
4. Remove the shock absorber (18125).
1. Remove and discard the bolt and nut.
2. Remove the shock absorber.
Installation
1. Correctly prime the new shock absorber.
2. Install a new washer and insulator on the shock absorber.
3. Position the shock absorber and install a new bolt and a new nut.
4. NOTE: When using a hoist that lifts the vehicle by the frame, have an assistant guide the shock absorber into the body while lowering the hoist.
Lower the vehicle.
5. Install a new insulator, washer and nut.
6. Position the carpet and close the luggage compartment lid.
Installation
1. NOTE: Inspect the spring insulators for wear or damage. Install new spring insulators if necessary. Make sure the spring insulators are correctly installed on the springs. 2. Install the spring ...Damper
Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...Other materials:
Engine Front Cover
Material
Item
Specification
Metal Surface Cleaner
F4AZ-19A536-RA or equivalent
WSE-M5B392-
A
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-
A4
SAE 5W-30 Premium Synthetic
Blend Motor Oil
XO-5W30-QSP ...
Climate Control System - General Information
General Specifications
a - Manifold gauge set pressures may vary slightly depending on the distance
between the service gauge port valve and the A/C pressure relief valve, the A/C
cycling switch, the pressure cutoff switch
(V6), and the dual function press ...
Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously
- RCM
Disconnected, Inoperative or Lost/Low Ignition Feed
Normal Operation
NOTE: During normal operation the air bag indicator will be lit continuously
for 6 seconds after the
ignition switch is placed in the RUN position and after five cycles of a lamp
fault code (LFC) if a fault
exists. Be sure to cycle the ignit ...