Ford Mustang (1999-2004) Service Manual: Special Operating Condition Requirements

When towing a trailer or using a camper or car-top carrier:

  • Change engine oil and install a new oil filter every 4,800 km (3,000 miles) or 3 months.
  • Change transfer case fluid every 96,000 km (60,000 miles).
  • Change manual transmission fluid as required.
  • Inspect and lubricate U-joints as required.

During extensive idling and/or low speed driving for long distances, as in heavy commercial use such as delivery, taxi, patrol car or livery:

  • Change engine oil and install a new oil filter, lube front lower control arm and steering linkage ball joints with zerk fittings (if equipped) every 4,800 km (3,000 miles) or 3 months.
  • Inspect brake system and check battery electrolyte level (Patrol cars) every 8,000 km (5,000 miles).
  • Install a new fuel filter every 24,000 km (15,000 miles).
  • Change automatic transmission fluid, lubricate 4x2 wheel bearings, install new grease seals and adjust bearings every 48,000 km (30,000 miles).
  • Install new spark plugs and change transfer case fluid every 96,000 km (60,000 miles).
  • Install a new cabin air filter as required.

When operating in off-road conditions:

  • Change automatic transmission fluid every 48,000 km (30,000 miles).
  • Change transfer case fluid every 96,000 km (60,000 miles).
  • Install a new cabin air filter as required.
  • Inspect and lubricate U-joints.
  • Inspect and lubricate steering linkage ball joints with zerk fittings.
    General Maintenance Information
    NOTE: This is a generic maintenance schedule for all Ford, Lincoln and Mercury vehicles. There may be items listed that do not apply to all vehicles. The Normal Schedule applies to operation of the ...

    Checks and Services
    Certain basic maintenance checks and inspections should be carried out at specified intervals. Any recognized adverse condition should be corrected as soon as possible. Maximum Oil Change Interval (N ...

    Other materials:

    Installation
    1. CAUTION: To prevent refrigerant system contamination, do not allow dirt or other foreign materials to enter the A/C compressor. Clean the A/C compressor nose area. 2. Place the shaft seal on the special tool. Lubricate the shaft seal and the special tool ...

    Hydraulic Control Unit
    Removal 1. Disconnect the battery ground cable(14301). 2. Disconnect the anti-lock-brake control module electrical connector. 3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction control is shown , the 4WABS without traction control system is ...

    Trim Panel - Quarter, Convertible
    Special Tool(s) Safety Belt Bolt Bit 501-010 (T77L-2100-A) Removal and Installation 1. Lower the convertible top to the full down position. 2. Remove the rear seat cushion. 3. Remove the two bolts and the rear seat backrest. 4. Remove ...