Ford Mustang (1999-2004) Service Manual: Spindle
Special Tool(s)
Tie-Rod End Remover 211-001 (TOOL-3290-D) or Equivalent |
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure correct retention of these parts.
1. Raise the vehicle on a hoist.
2. Remove the wheel and tire assembly.
3. Remove the front wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section.
4. Remove the bolt and the ABS sensor.
5. Unclip the ABS sensor wire from the bracket.
6. Remove the front brake disc shield.
1. Remove the three shield rivets.
2. Remove the shield.
7. Remove the cotter pin and nut. Discard the cotter pin.
8. CAUTION: Use care not to damage the tie-rod end dust boot. Using the special tool, disconnect the tie-rod end from the front wheel spindle.
9. CAUTION: To prevent damage to the front suspension lower arm (3078), do not remove the nut from the ball joint (3050) at this time.
Disconnect the ball joint stud from the front wheel spindle (3105).
- Loosen the ball joint stud two or three turns.
- Sharply rap on the spindle at the ball joint connection to disconnect the ball joint stud.
10. Support the front suspension lower arm with a jack stand.
11. Remove the nut and the ABS sensor wire bracket.
12. WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. Failure to follow these instructions can result in personal injury.
Disconnect the front shock absorber (18124) from the spindle.
1. Remove and discard the nuts and bolts.
2. Disconnect the shock absorber.
13. Remove the spindle.
1. Remove and discard the nut.
2. Remove the spindle.
Installation
1. To install, reverse the removal procedure.
2. Check wheel alignment. Adjust if necessary.
Bushing - Stabilizer Bar
Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...Shock Absorber
Removal WARNING: All vehicles are equipped with gas pressurized shock absorbers which will extend unassisted. Do not apply heat or flame to the shock absorbers during removal or component servicing. ...Other materials:
Starting a gasoline engine
When you start the engine, the idle speed increases, this helps to warm
up the engine. If the engine idle speed does not slow down automatically,
have your vehicle checked by an authorized dealer.
Before starting the engine:
• Make sure all occupants have f ...
Removal
CAUTION: Electronic modules are sensitive to static electrical
charges. If exposed to
these charges, damage may result.
1. Remove the driver air bag module. For additional information,
refer to Section.
2. Remove the passenger air bag module. For ...
Power seats
WARNING: Never adjust the driver’s seat or seat back when the
vehicle is moving.
WARNING: Before returning the seat back to its original
position, make sure that cargo or any objects are not trapped
behind the seat back.
The power seat control is located
on ...