Ford Mustang (1999-2004) Service Manual: Stay Pad - Convertible Top
Removal
1. Remove the convertible top material. For additional information, refer to Convertible Top Material in this section.
2. Remove the rear window glass. For additional information, refer to Convertible Top Assembly- Rear Window Glass in this section.
3. NOTE: Mark the old stay pad staple locations and transfer to the new stay pads.
Remove the staples from all of the bows.
Installation
1. Staple the stay pad to the number one bow.
2. NOTE: The stay pad should be tight between the number one and number four bows.
Staple the stay pad to the number four bow.
3. Cut the excess stay pad material from the rear of the number four bow.
4. Staple the stay pad to the number two bow.
5. Staple the stay pad to the number three bow.
6. Install the rear window glass. For additional information, refer to Convertible Top Assembly- Rear Window Glass in this section.
7. Install the convertible top material. For additional information, refer to Convertible Top Material in this section.
Convertible Top Switch
Removal and Installation
1. Remove the floor console. For additional information, refer to Section.
2. Remove the convertible top switch.
1. Disconnect the electrical connector.
2. Release the clips.
3. To install, reverse the removal procedure.
Installation
1. Align the center mark on the cover assembly to the V-notch on the rear glass assembly and staple the entire length of the number four bow. 2. Center the listing sleeve on the bottom of the foldi ...Other materials:
Removal
1. Disconnect the electrical connectors from the EGR vacuum regulator
solenoid, the
supercharger bypass vacuum solenoid, and the differential pressure
feedback EGR system.
2. Disconnect the vacuum hoses from the differential pressure feedback EGR
sy ...
Engine (Removal)
Special Tool(s)
Lifting Bracket, Engine
303-D087 (D93P-6001-A1)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Spreader Bar
303-D089 (D93P-6001-A3)
Removal
All vehicles
1. Disconnect the battery ground cable. Fo ...
Mass Air Flow (MAF) Sensor - 3.8L
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing
element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not
damage the sensing
element (internal to housing) or possible failure to the mass air f ...