Ford Mustang (1999-2004) Service Manual: Steering Column Shaft
Removal and Installation
1. CAUTION: Do not allow the steering column shaft to rotate while intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the steering column shaft has rotated the clockspring must be removed and recentered.
NOTE: Discard the steering column shaft pinch bolt and the lower intermediate shaft-to-steering gear pinch bolt. Do not reuse, install new bolts.
Remove and discard the steering column shaft pinch bolt and disconnect the intermediate from the coupling.
2. Raise and support the vehicle.
3. Remove the pinch bolt.
4. Disconnect the intermediate shaft from the gear and remove the intermediate shaft.
5. To install, reverse the removal procedure.
Column
Removal and Installation All vehicles 1. Disconnect the battery ground cable and wait at least one minute to allow the depletion of the restraint system backup power supply. 2. WARNING: To avoid ...Coupling
Removal and Installation 1. CAUTION: Do not allow the steering column shaft to rotate while intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the ...Other materials:
Installation
CAUTION: The upper suspension arm and bushing nuts must be tightened
with the
suspension at curb height. Failure to do so can result in bushing failure,
resulting in poor ride
and handling.
NOTE: If installing a new upper suspension arm and bushing, mark the ...
Removal
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet pipe.
3. Remove the radiator sight shield.
4. Remove the coolant recovery reservoir.
1. Disconnect the hose.
2. Remove the bolts.
3. Remove the coolant recovery reservoir ...
Crankshaft End Play
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. Measure the crankshaft end play. Use a Dial Indicator Gauge with Holding
Fixture to measure
crankshaft end play.
2. Position the crankshaft t ...