Ford Mustang (1999-2004) Service Manual: Steering Column Switches
Torque Specifications
Steering Column Switches (DESCRIPTION AND OPERATION)
The steering column switches system consists of the following components:
- multifunction switch (13K359)
- key release button (manual transmission only) (3F527)
- ignition switch (11572)
The integrated multifunction switch is mounted to the LH side of the steering column and controls the turn signals, hazard flasher, windshield wiper/washer control, and headlamp dimmer/flash-to-pass.
The key release button is equipped with manual transmissions only.
The ignition switch is mounted below the steering column and is activated by rotating the key lock cylinder on the steering column.
- Steering Column Switches (Diagnosis and Testing)
- Multifunction Switch
- Ignition Switch
- Key Release Button
Assembly
1. Install the locking lever cam and pin. 2. Install the lock actuator lever and pin. 3. Install the lock actuator lever return spring. 4. Install the ignition lock cylinder lockout lever. 5. ...Steering Column Switches (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 13 , Power Distribution for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Refer ...Other materials:
Starter Drive and Flywheel Ring Gear Inspection
1. Remove the starter motor. For additional information, refer to Starter
Motor-3.8L or Starter
Motor-4.6L in this section.
2. Check the wear patterns on the starter drive gear and the flywheel ring
gear . If the wear pattern
is normal, install the sta ...
Lumbar Assembly
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
2. Release the J-clip.
3. Remove the seat backrest latch handle knob (62762).
4. Pull the seat backrest trim cover ...
Installation
1. Lubricate the lip of the wheel bearing oil seal
Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford
specification ESAM1C75-
B.
2. CAUTION: Do not damage the wheel bearing oil seal.
Install the two axle shafts.
3. CAUTION: Do not damage th ...