Ford Mustang (1999-2004) Service Manual: Striker Adjustment
NOTE: After adjusting the door latch striker plate, verify that the door can be closed easily and fits tightly.
1. Loosen the door latch striker plate bolts.
2. Reposition the door latch striker plate from side to side or up and down as necessary.
3. Tighten the door latch striker plate bolts.
4. Check the adjustment. Repeat the procedure as necessary.
Door Alignment
NOTE: The door should be adjusted for even and parallel fit with the body opening and surrounding panels as well as making sure that the anti-chuck pin is not binding on convertible models. ...Door
Removal 1. Remove the door trim panel. For additional information, refer to Section. 2. Disconnect the necessary electrical connectors to remove the harness and grommet from the door. ...Other materials:
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if installation becomes necessary. ...
Fuel quality
Note: Use of any fuel other than those recommended may cause
powertrain damage and a loss of vehicle performance; repairs may not be
covered under warranty.
Choosing the Right Fuel
Use only unleaded fuel or unleaded fuel blended with a maximum of
15% ethanol. ...
Heater Core
Removal
NOTE: If a heater core leak is suspected, the heater core must be
pressure leak tested before it is
removed from the vehicle. For additional information, refer to Section.
1. Remove the evaporator core housing. For additional information, refer to
E ...