Ford Mustang Service Manual: Stub Shaft Pilot Bearing and Seal
Rear Drive Axle and Differential
- The differential housing (4010) consists of a cast aluminum housing and a cast aluminum differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket.
- The hypoid-design gearset consists of a 8.8-inch differential ring gear
and a drive pinion gear.
Two opposed pinion bearings (4621) (4630) support the drive pinion gear in the differential housing.
- A differential drive pinion collapsible spacer (4662), located on the drive pinion gear shaft, maintains pinion bearing preload. The pinion nut adjusts the preload.
- Differential bearing shims (4067), located between the differential bearing cups (4222) and the differential housing, adjust the differential ring gear backlash and the differential bearing preload.
- The differential case (4204) is a one-piece design with two openings to allow for assembly of the internal components and lubricant flow. Two opposed differential bearings (4221) support the differential case in the differential housing. Removable differential bearing caps retain the differential assembly in the differential housing.
- Inside the differential case, the differential pinion shaft (4211) supports two differential pinion gears (4215). The pinion gears engage the differential side gears (4236), to which the halfshafts are splined. The differential pinion shaft lock bolt retains the differential pinion shaft in the differential case.
- A circlip, located on the inboard CV joint stub shaft, holds the
halfshaft in the differential case.
When installed, the circlip engages a groove in the differential side gear.
- The rear axle uses SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.
- An embossed metal tag, bolted to the differential housing cover, contains rear axle identification.
Rear Drive Axle and Differential
Rear Drive Axle and Differential The differential housing (4010) consists of a cast aluminum housing and a cast aluminum differential housing cover (4033). The differential housing c ...Drive Pinion Flange
Rear Drive Axle and Differential The differential housing (4010) consists of a cast aluminum housing and a cast aluminum differential housing cover (4033). The differential housing c ...Other materials:
Upper Arm
Rear Suspension (Description and Operation)
Item
Part Number
Description
1
18125
Rear shock absorber
2
-
Rear axle driveline vibration damper
3
5A649
Rear lower suspension arm and bushing (common
LH and RH)
...
General information
Radio Frequencies and Reception Factors
AM and FM frequencies are established by the Federal Communications Commission
(FCC) and the Canadian Radio and Telecommunications Commission (CRTC). Those frequencies
are:
AM: 530, 540–1700, 1710 kHz FM: 87.9–107. ...
Installation
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
and can ignite. Failure to follow these instructions can result in personal
in ...