Ford Mustang (1999-2004) Service Manual: Switch
Removal
1. Remove the climate control assembly. For additional information, refer to Control Assembly in this section.
2. NOTE: All three switches are removed the same.
Remove the knob.
3. Remove the screw.
4. Rotate the switch and remove it from the control head assembly.
Installation
1. To install, reverse the removal procedure.
Actuator -Temperature Control Cable
Removal
1. Remove the control assembly. For additional information, refer to Control Assembly in this section.
2. Unsnap and remove the drive assembly.
Installation
1. To install, reverse the removal procedure.
Installation
1. Align the blend door driver to the full heat position. 2. Place the temperature control knob in the full WARM position. 3. Attach the cable drive to the control head. 4. Rotate the knob back ...Resistor
Removal 1. Disconnect the connector. 2. Remove the screws. 3. Remove the resistor. Installation 1. To install, reverse the removal procedure. ...Other materials:
Window Glass - Door
Removal
1. Remove the door trim panel. For additional information, refer to
Section.
2. Remove the interior weatherstrip.
3. Remove the bolts and the stabilizers.
4. Remove the bolts and the upstop brackets.
5. Remove the rivet and the exterior w ...
Removal
1. Remove the rear exterior trim mouldings.
2. Remove the clips
3. Remove the 13 Torx screws and the seal compression panel.
4. Remove the staples.
5. Remove the staples from the number one bow.
6. Remove the rear rail weatherstrip retainers from ea ...
Supplementary Restraints System
PRINCIPLES OF OPERATION
WARNING: Airbags do not inflate slowly or gently, and the risk
of injury from a deploying airbag is the greatest close to the trim
covering the airbag module.
WARNING: All occupants of your vehicle, including the driver,
should always p ...