Ford Mustang (1999-2004) Service Manual: Switch - Door Lock
Removal
1. CAUTION: Place a rag between the window regulator switch plate and the door trim panel to avoid damaging the door trim panel.
Position the window regulator switch plate (14524) aside.
1. Pull at service notch.
2. Lift to release the clip at the rear edge.
2. Remove the screws and the door lock switch (14017).
Installation
1. To install, reverse the removal procedure.
Keyless Entry
The electronic door lock system has two main components:
- generic electronic module (GEM)(14B204)
- keyless entry remote transmitter (15K601)
Actuator - Door Lock
Removal 1. Remove the door trim panel (23942). For additional information, refer to Section. 2. Remove the door latch (21812). For additional information, refer to Latch-Door . 3. Remove ...Keyless Entry (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for schematic and connector information. Refer to Wiring Diagrams Cell 111 , Remote Keyless Entry (RKE) for schematic and connec ...Other materials:
Pinpoint Test D: LFC 15/DTC B 1887- Driver Air Bag Circuit Shorted to
Ground
Normal Operation
The restraints control module (RCM) checks for driver air bag circuit
shorts to ground by monitoring the
voltage of circuits 614 (GY/OG) and 615 (GY/WH) at pins 3 and 4. If the RCM
detects a short to
ground on either of these pins, it w ...
Motor - Windshield Wiper
Removal
CAUTION: The internal permanent magnets used in the windshield
wiper motor are made
of a glass-like material. To avoid damaging the magnets, do not strike
the motor with a hammer
or any other object.
NOTE: The windshield wiper motor is n ...
Installation
WARNING: To reduce the risk of serious personal injury, read
and follow all warnings,
cautions and notes at the beginning of the removal procedure.
1. Install the passenger air bag module.
1. Position the passenger air bag module into the instrume ...