Ford Mustang (1999-2004) Service Manual: Switch - Horn
Removal
1. Remove the driver side air bag module (043B13). Refer to Section.
2. Remove the switches.
1. Disconnect the horn wire from the switches.
2. Remove the horn switch screws and remove the switches.
Installation
1. To install, reverse the removal procedure.
- Prove out the air bag system. Refer to Section.
Horn (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 44 , Horns/Cigar Lighter for schematic and connector information. Special Tool(s) 73 Digital Multimeter or equivalent 105-R0051 Inspection and Veri ...Warning Devices
Warning Devices The warning device system consists of the following components: door ajar switches generic electronic module (GEM) key-in-ignition warning switch safety belt switch ...Other materials:
Wheel And Tire
Removal
1. CAUTION: Do not use heat to loosen a seized wheel nut (1012). Heat
can damage
the wheel and wheel bearings.
NOTE: To avoid damage or scratching to the center cap, place facing up
when removed.
Loosen the wheel nuts.
1. NOTE: To avoid wheel damag ...
Component Tests
Brake Booster
1. Check the hydraulic brake system for leaks or insufficient fluid.
2. With the transmission (7003) in NEUTRAL, stop the engine (6007) and
apply the parking brake
control (2780). Apply the brake pedal several times to exhaust all
va ...
Caliper
1. NOTE: It is not necessary to do a complete brake system
bleed if only the disc brake caliper
(2B120) was disconnected.
Place a box end wrench on the disc brake caliper bleeder screw (2208).
Attach a rubber drain
tube to the disc brake caliper b ...