Ford Mustang (1999-2004) Service Manual: Switch - Seat Regulator Control
Removal and Installation
1. Disconnect the battery. For additional information, refer to Section.
2. Remove the screws and position the seat regulator control switch aside.
3. Disconnect the electrical connector and remove the seat regulator control switch.
4. To install, reverse the removal procedure.
Seats (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 120 , Power Seats for schematic and connector information. Refer to Wiring Diagrams Cell 122 , Power Lumbar Seats for schematic and connector information. Special ...Lumbar Control Switch
Removal and Installation All vehicles 1. Remove the front seat. For additional information, refer to Seat-Front Power in this section. Vehicles with standard power lumbar 2. Pull to remove the l ...Other materials:
Symptom Chart
Condition
Possible Sources
Action
Difficult
starting
Damaged ignition
system.
Damaged fuel
system.
Damaged starting
system.
Damaged charging
system/battery.
Burnt valve.
Worn piston.
Worn pi ...
Trim Panel - Package Tray
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal and Installation
1. Remove the screw and the coat hook.
2. NOTE: Inspect the shoulder safety belt guide cover for damage. If the
shoulder safety belt guide
cover is d ...
Brake Booster - Hydro-Boost (Removal and Installation)
Special Tool(s)
Installer Set, Teflon Seal
211-D027 (D90P-3517-A) or
equivalent
Removal
WARNING: The power brake booster should not be carried by the
accumulator, nor
should it ever be dropped on the accumulator. Check the snap ring on th ...