Ford Mustang (1999-2004) Service Manual: Switch - Speed Control Actuator
Removal
1. Remove the steering wheel; refer to Section.
2. Remove the steering wheel rear cover.
1. Remove the screws.
2. Remove the steering wheel rear cover.
3. Remove the ribbon harness from the clips.
4. Remove the horn contact electrical connectors.
5. Remove the right side horn contact.
1. Remove the screws.
2. Remove the contact.
6. Remove the speed control actuator switch assembly.
1. Remove the screws.
2. Remove the speed control actuator switch assembly.
Installation
1. To install, reverse the removal procedure.
Switch - Deactivator
Removal 1. Disconnect the battery ground cable. 2. Remove the deactivator switch. 1. Disconnect the deactivator switch electrical connector. 2. Detach the lower deactivator switch hook. 3 ...Other materials:
Brake Booster - Hydro-Boost (Description and Operation)
The Hydro-Boost brake booster is a hydraulically operated brake booster
powered by the power
steering pump (3A674). The power steering pump provides the fluid pressure to
operate both the
power brake booster and the power steering gear (3504).
A Hydro-Boost ...
Dowels - Flywheel Housing to Block
Removal
1. NOTE: Take care not to damage the flywheel housing to block dowel
holes or the surface areas
around the flywheel housing to block dowel hole during removal.
Remove the two flywheel housing to block dowels using a drift pin where the
flywheel ...
Latch - Front Seat Backrest
Removal
NOTE: The power seat backrest adjuster assembly must be installed as a
new unit. Repair of the
power seat backrest adjuster assembly components is not acceptable and
should not be attempted.
1. Remove the two screws and the seat backrest latch ...