Ford Mustang (1999-2004) Service Manual: System Bleeding

1. If required, remove the hydraulic system from the vehicle. Refer to Hydraulic System, Lift Cylinder and Motor in this section.

2. Remove the fill plug at the end of the hydraulic pump.

System Bleeding

3. Fill the pump with Mercon Multi-Purpose Automatic Transmission Fluid XT-2-QDX or equivalent to the bottom of the fill hole and install the fill plug.

System Bleeding

4. NOTE: Some noise squeal may be noticed due to the air in the system.

Connect a 12-volt power source to the motor connector and operate the motor until the cylinders are fully extended. Reverse the 12-volt connection to fully retract the cylinders. Repeat this procedure three times.

5. Remove the fill plug and check the fluid level. Fill the pump with MERCON Multi-Purpose Automatic Transmission Fluid XT-2-QDX or equivalent to the bottom of the fill hole.

System Bleeding

6. Install a fill plug.

System Bleeding

7. Install the hydraulic system in the vehicle. Refer to Hydraulic System, Lift Cylinder and Motor in this section.

    Convertible Top (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 103 , for schematic and connector information. Special Tool(s) 73 III Automotive Meter 105-R0057 or equivalent Principles of Operation The converti ...

    Other materials:

    Inspection and Verification
    1. Verify the customer concern by operating the wiper/washer system. 2. Visually inspect for obvious signs of mechanical and electrical damage. Visual Inspection Chart Mechanical Electrical Hoses to windshield washer pump Wiper l ...

    Installation
    1. CAUTION: Make sure the hardened washer is installed between the lower suspension arm and bushing and the shock absorber. Failure to do so can result in damage and failure of the lower suspension arm and bushing. NOTE: The toe link bolt and nuts are of a ...

    Removal
    1. Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold in this section. 2. Partially drain the cooling system. For additional information, refer to Section. 3. Relieve the fuel system pressure. For additional i ...