Ford Mustang (1999-2004) Service Manual: System Flushing - CII Power Steering Pump
WARNING: Do not mix oil types. Any mixture or any unapproved oil can lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.
1. Remove the fuel pump fuse from the battery junction box.
2. Disconnect the power steering return hose. Plug the reservoir.
3. Attach an extension hose between the power steering return hose and an empty container.
4. Raise the front wheels off the floor. 5. Check the fluid level. If necessary, fill the reservoir to the correct level.
- Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.
6. CAUTION: Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature starter failure can occur.
CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur.
Turn the steering wheel from stop-to-stop while cranking the engine until the fluid exiting the power steering return hose is clear of all contamination and foreign material.
- Add Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent as needed.
7. Lower the vehicle.
8. Disconnect the extension hose from the power steering return hose. Remove the plug. Attach the power steering return hose to the reservoir.
9. CAUTION: Do not overfill the reservoir.
Check the fluid level. If necessary, fill the reservoir to the correct level.
- Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.
10. Install the fuel pump fuse.
11. CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur.
Start the engine and turn the steering wheel from stop-to-stop.
12. CAUTION: Do not overfill the reservoir.
NOTE: If the power steering system is noisy and is accompanied by evidence of aerated fluid it will be necessary to purge the power steering system.
Check the fluid level. If necessary, fill the reservoir to the correct level.
- Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.
Component Tests
Steering Linkage 1. NOTE: Excessive vertical motion of the studs relative to the sockets may indicate excessive wear. With the parking brake applied, perform the following: Have an assistant rotat ...System Flushing - CIII Power Steering Pump
WARNING: Do not mix oil types. Any mixture or any unapproved oil can lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering ass ...Other materials:
Fuel Charging and Controls
The fuel injection supply manifold (9F792):
delivers fuel to the fuel injector.
receives fuel from the fuel supply line.
The throttle body:
controls air supply to the upper intake manifold by positioning the
throttle plate.
connects the accelerator ca ...
Weld Nut Repair - Missing Weld Nut,
Restraints Control
Module (RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...
Closing the convertible top
Note: The convertible top will not operate unless the vehicle is
stationary or traveling under 3 mph (5 kmh).
Note: Make sure that the latch handles are pulled down and in the fully
opened position before the top makes contact with the windshield
header. This ...