Ford Mustang (1999-2004) Service Manual: Installation
1. CAUTION: Make sure the hardened washer is installed between the lower suspension arm and bushing and the shock absorber. Failure to do so can result in damage and failure of the lower suspension arm and bushing.
NOTE: The toe link bolt and nuts are of a torque prevailing design. A new bolt and new nuts must be installed.
NOTE: Use a new cotter pin.
To install, reverse the removal procedure.
2. Check wheel alignment. Adjust as necessary.
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part ...Spring - Coil
Special Tool(s) Hi-Lift Jack 014-00942 or Equivalent ...Other materials:
Component Tests
Engine Oil Leaks
NOTE: When diagnosing engine oil leaks, the source and location of
the leak must be positively
identified prior to repair.
Prior to carrying out this procedure, clean all sealing surface areas with a
suitable solvent to remove all
tra ...
Valve Springs
Special Tool(s)
Compressor, Valve Spring
303-163 (T81P-6513-A)
Material
Removal
1. Remove the LH and the RH valve covers. For additional information,
refer to Valve Cover-LH
and Valve Cover RH in this section.
2. Rotate the crankshaft un ...
Transmission Connector Layouts
Transmission Vehicle Harness Connector
Transmission Internal Harness Connector
Digital Transmission Range (TR) Sensor Connector
Output Shaft Speed (OSS) Sensor Harness Connector
Digital Transmission Range (TR) Senso ...