Ford Mustang (1999-2004) Service Manual: Torque Converter Impeller to Pump Stator Interference Check
1. NOTE: Front pump support may remain in front pump support and gear during this test.
Position the front pump support with the splines up.
2. Mount the torque converter on the front pump support with the splines on the one-way clutch inner race, engaging the mating splines of the front pump support.
3. Hold the front pump support stationary and rotate the torque converter counterclockwise.
- The torque converter should rotate freely with no signs of scraping.
- If there are signs of scraping, install a new or remanufactured torque converter.
Torque Converter Leak Check
Special Tool(s)
Leak Tester, Torque Converter
307-421
1. Clean the outside surface of the torque converter.
2. Install the special tool into the converter hub.
3. WARNING: Always fo ...
Torque Converter End Play Check
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
End Play Gauge, Torque
Converter
307-071 (T80L-7902-A) or
equivalent
...
Other materials:
System Flushing - CII Power Steering Pump
WARNING: Do not mix oil types. Any mixture or any unapproved oil can
lead to seal
deterioration and leaks. A leak can ultimately cause loss of fluid, which can
result in a loss of
power steering assist.
1. Remove the fuel pump fuse from the battery junction ...
Removal
1. Drain the engine cooling system.
2. Remove the air cleaner outlet tube.
3. Disconnect the fuel line.
4. Disconnect the upper radiator hose from the water outlet connector.
5. Disconnect and remove the upper radiator hose.
6. Disconnect the acce ...
Safety Belt Buckle - Front Seat
Removal
Driver and passenger seat
1. Remove the front seat. For additional information, refer to Section.
2. Remove the nut and the safety belt buckle.
Driver seat only
3. Disconnect the safety belt buckle electrical connector.
Installation
1. To install, ...
