Ford Mustang (1999-2004) Service Manual: Torque Converter Turbine to Pump Stator Interference Check
1. NOTE: Front pump support may remain in front pump support and gear during this test.
Position the torque converter with the pump drive up.
2. Install the front pump support to engage the mating splines of the front pump support shaft on the torque converter.
3. Install the forward clutch cylinder and shaft, engaging the splines with the rear clutch hub.
4. Check for stator to turbine interference.
1. Hold the front pump support stationary.
2. Attempt to rotate the forward clutch cylinder and shaft.
- The turbine and torque converter clutch assemblies should rotate in both directions, not exceeding maximum torque of 9.5 Nm (7 lb-ft), without any signs of metallic interference or scraping noise.
5. If interference exists, the stator front thrust washer may be worn, allowing the stator to hit the turbine. In such cases, a new or remanufactured torque converter must be installed.
- The converter crankshaft pilot should be checked for nicks or damaged surfaces that could cause interference when installing the torque converter into the crankshaft. Check the converter front impeller hub for nicks or sharp edges that would damage the pump seal.
Torque Converter End Play Check
Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent End Play Gauge, Torque Converter 307-071 (T80L-7902-A) or equivalent ...Transmission (ASSEMBLY)
Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) Rubber Tip Air Nozzle 100-D009 (D93L-7000-A) Alignment Gauge, TR Sensor 307-3 ...Other materials:
Air Conditioning (A/C) System Recovery, Evacuation and Charging
Special Tool(s)
R-134a A/C Refrigerant Center
176-00002 or equivalent
R-134a A/C Refrigerant Center
023-00153 or equivalent
R-134a Manifold Gauge Set
176-R032A or equivalent
1.2 CFM Vacuum Pump
023-00162 o ...
Compressor to Condenser Discharge Line - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when
repairing the ...
Mirror - Motor
Removal
1. Push in the upper edge of the mirror glass to the maximum travel.
2. Grasp the bottom of the mirror glass, pull outward and remove the mirror
glass.
3. Remove the mirror motor screws.
4. Disconnect the mirror motor electrical connector.
5. ...