Ford Mustang (1999-2004) Service Manual: Transmission Support Crossmember
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to Section.
2. Support the transmission with a suitable transmission jack.
3. Remove the crossmember.
1. Disconnect the HO2S sensors and position them aside.
2. Remove the bolts from the crossmember to the extension housing.
3. Remove the bolts from the crossmember to the body and remove the crossmember.
4. To install, reverse the removal procedure.
2-3 Accumulator
Removal 1. Remove the main control valve body. For additional information, refer to Main Control Valve Body in this section. 2. Remove the 2-3 accumulator piston retainer. 3. Remove the accumulato ...Transmission (REMOVAL)
Special Tool(s) Retainer, Torque Converter 307-346 (T97T-7902-A) CAUTION: Whenever a transmission has been disassembled to install new parts the transmission fluid cooler tubes must b ...Other materials:
Lower Arm
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expense. A
new part with
the same part number must be installed if installation becomes nec ...
Lifting
CAUTION: Do not allow the lift adapters to contact the steering
linkage, suspension arms,
stabilizer arms, or to compress the lower suspension arm stabilizer bar
insulator (5493).
Damage to the suspension, exhaust and steering linkage components may occur i ...
Air filter check
WARNING: To reduce the risk of vehicle damage and or
personal burn injuries, do not start your engine with the air
cleaner removed and do not remove it while the engine is running.
Note: Failure to use the correct air filter element may result in
severe
engin ...