Ford Mustang (1999-2004) Service Manual: Trim Panel - Upper Quarter
Special Tool(s)
Safety Belt Bolt Bit 501-010 (T77L-2100-A) |
Removal and Installation
1. Remove the rear seat cushion.
2. Using the special tool, remove the rear safety belt anchor bolt.
3. Remove the screw and the coat hook.
4. Open the front safety belt guide bolt cover.
5. Using the special tool, remove the front safety belt guide bolt.
6. Remove the upper quarter trim panel.
7. To install, reverse the removal procedure.
Trim Panel - Quarter, Convertible
Special Tool(s) Safety Belt Bolt Bit 501-010 (T77L-2100-A) Removal and Installation 1. Lower the convertible top to the full down position. 2. Remove the rear seat cushion. 3. ...Trim Panel - Package Tray
Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal and Installation 1. Remove the screw and the coat hook. 2. NOTE: Inspect the shoulder safety belt guide cov ...Other materials:
Connecting Rod - Side Clearance
1. Measure the clearance between the connecting rod and the crankshaft.
Verify the measurement
is within specification.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
...
Runout Check - Brake Disc and Hub
Special Tool(s)
Brake Measurement Kit
134-R0199 or equivalent
Material
Item
Specification
High Temperature Nickel Anti-
Seize Lubricant
F6AZ-9L494-AA
ESE-M12A4-
A
CAUTION: The brake disc (1126) runout specification must ...
Pilot Bearing
Special Tool(s)
Puller with Slide Hammer
308-001 (T58L-101-B)
1. Remove the clutch disc and the clutch pressure plate. For additional
information, refer to Disc
and Pressure Plate-3.8L and 4.6L (2V) Engines or Disc and Pressure Plate-4.6L
(4V ...