Ford Mustang (1999-2004) Service Manual: Vacuum Control Motor - Air Damper Door
Removal
1. Remove the instrument panel. For additional information, refer to Section.
2. Disconnect the vacuum hose.
3. Remove the vacuum control motor.
1. Remove the steel clip.
2. Loosen the nuts.
Installation
1. To install, reverse the removal procedure.
Vacuum Control Motor -Windshield/Defroster Door
Removal
1. Remove the instrument panel. For additional information, refer to Section.
2. Unclip the control arm.
3. Remove the vacuum control motor.
1. Disconnect the vacuum lines.
2. Loosen the nuts.
Installation
1. To install, reverse the removal procedure.
Vacuum Reservoir Tank
Removal
1. Access the vacuum reservoir tank through the glove compartment.
2. Remove the reservoir.
1. Disconnect the vacuum connector.
2. Remove the screw.
Installation
1. To install, reverse the removal procedure.
Vacuum Control Motor - Air Inlet Duct Door
Removal 1. Remove the instrument panel. 2. Disconnect the vacuum hose. 3. Disconnect the control arm. 4. Remove the vacuum control motor. Remove the screws. Installation 1. To install, reve ...Other materials:
Installation
1. Clean the A/C disc and field coil and pulley mounting surfaces.
2. CAUTION: Do not use air tools. The A/C clutch field coil can be easily
damaged.
Install the A/C clutch field coil.
1. Place the A/C clutch field coil on the A/C compressor with the A/C
...
Brake Booster - Vacuum (Description and Operation)
Power Brake Booster
The vacuum type power brake booster (2005):
is a dual diaphragm, vacuum assisted power brake booster
reduces brake pedal force and travel distance.
is located on the LH side of the bulkhead in the engine compartment,
be ...
Disassembly
1. NOTE: Mark the position of each gear shifter fork (7230).
Place the gear shift plates (7N232) and the gear selector interlock sleeve
(7K201) in the neutral
position to center the gear shift plates and the selector body (7302).
2. Rotate the main shif ...