Ford Mustang (1999-2004) Service Manual: Valve Cover - LH
Removal and Installation
1. Position the ignition wires (12281) aside.
2. Disconnect the positive crankcase ventilation (PCV) valve (6758).
3. Remove the ignition coil and position aside.
1. Disconnect the electrical connector.
2. Disconnect the accelerator control cable retainer.
3. Remove the bolts.
4. Remove the LH valve cover (6A565).
- Inspect the gasket (6584) and install a new gasket if necessary.
5. To install, reverse the removal procedure.
Installation
1. NOTE: If the lower intake manifold is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign ...Valve Cover RH
Removal and Installation 1. Remove the throttle body. For additional information, refer to Section. 2. Disconnect the crankcase vent hose. 3. Remove the differential feedback exhaust gas recirc ...Other materials:
Anti-Theft - Passive Anti-Theft System (PATS) (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 112 , Anti-Theft for schematic and connector
information.
Refer to Wiring Diagrams Cell 60 , Instrument Cluster for schematic and
connector information.
Special Tool(s)
73III Automotive Meter
105-R0057 or equivalen ...
Wheel Bearing Check
1. WARNING: The electrical power to the air suspension system must be
shut off prior
to hoisting, jacking or towing an air suspension vehicle. This can be
accomplished by
turning off the air suspension switch. Failure to do so can result in unexpected
infla ...
Warning lamps and indicators
These indicators can alert you to a vehicle condition that may become
serious enough to cause expensive repairs. Many lights will illuminate
when you start your vehicle to make sure they work. If any light remains
on after starting the vehicle, refer to the re ...