Ford Mustang (1999-2004) Service Manual: Valve Seals
Special Tool(s)
Valve Spring Compressor 303-452 (T93P-6565-AR) | |
Valve Stem Seal Replacer 303-383 (T91P-6571-A) | |
Compressor, Valve Spring (Exhaust) 303-567 (T97P- 6565-AH) |
Material
Item | Specification |
Super Premium SAE 5W-20 Motor Oil XO-5W20-QSP | WSS-M2C153- H |
Removal and Installation
1. Remove the roller followers. For additional information, refer to Camshaft Roller Follower in this section.
2. Remove the spark plug (12405) from the applicable cylinder.
3. Position the piston (6102) of the cylinder being serviced at the bottom of the stroke.
4. CAUTION: If air pressure has forced the piston to the bottom of the cylinder, any loss of air pressure will allow the valve to fall into the cylinder. If air pressure must be removed, support the valve prior to removal.
Use compressed air in the cylinder to hold both valves in position.
5. Using the special tool, compress the valve spring (6513).
6. NOTE: Valve stem seals should be visually inspected if not installing new seals.
Remove the valve stem seals.
1. Remove the valve spring retainer keys.
2. Remove the valve spring retainers.
3. Remove the valve springs.
4. Remove the valve stem seals.
7. NOTE: Lubricate the lip of the new seal with clean engine oil prior to installation.
To install, reverse the removal procedure.
Installation
1. CAUTION: The timing chain procedures must be followed exactly or damage to the valve and pistons will result. Compress the tensioner plunger, using an edge of a vise. 2. While holding the ratch ...Hydraulic Lash Adjuster
Removal and Installation 1. Remove the roller followers. For additional information, refer to Camshaft Roller Follower in this section. 2. Remove the eight hydraulic lash adjusters. 3. Inspect the ...Other materials:
SecuriLock® passive anti-theft system
Note: The system is not compatible with non-Ford aftermarket remote
start systems. Use of these systems may result in vehicle starting
problems and a loss of security protection.
Note: Metallic objects, electronic devices or a second coded key on the
same key ...
Caliper (DISASSEMBLY AND ASSEMBLY)
Disassembly
1. Remove the disc brake caliper (2B120). For additional information,
refer to Caliper in this
section.
2. Drain the remaining brake fluid from disc brake caliper.
3. Apply low air pressure to the fluid port in the disc brake caliper.
...
Throttle Position (TP) Sensor
Removal
NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar.
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the throttle position (TP) sensor.
Disconnect the connector.
Remove the screws, ...