Ford Mustang (1999-2004) Service Manual: Valve Spring Strength

Special Tool(s)

 Pressure Gauge, Valve/Clutch Spring 303-006 (TOOL-6513-DD) or equivalent

1. Use a Valve/Clutch Spring Pressure Gauge to check the valve spring for correct strength at the specified valve spring length.

  • Refer to the appropriate section in Group 303 for the procedure.
  • If out of specification, install new components as necessary. Refer to the appropriate section in Group 303 for the procedure.

Valve Spring Strength

    Valve Stem to Valve Guide Clearance
    Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent Clearance Gauge, Valve Guide 303-004 (TOOL-6505-E) or equivalent NOTE: Valve ...

    Valve - Seat Inspection
    Valve and Seat Refacing Measurements CAUTION: After grinding valves or valve seats, check valve clearance. 1. Check the valve head and seat. Check valve angles. Check margin width. Refer t ...

    Other materials:

    Trim Panel - Quarter, Convertible
    Special Tool(s) Safety Belt Bolt Bit 501-010 (T77L-2100-A) Removal and Installation 1. Lower the convertible top to the full down position. 2. Remove the rear seat cushion. 3. Remove the two bolts and the rear seat backrest. 4. Remove ...

    Crankshaft - Connecting Rod Journal Taper, Out of Round
    1. Measure the crankshaft connecting rod journal diameters in two directions perpendicular to one another at each end of the connecting rod journal. The difference in the measurements from one end to the other is the taper. Verify measurement is within t ...

    Removal
    1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the engine air cleaner outlet pipe. For additional information, refer to Section. 3. Disconnect the vacuum hose and the idle air control (IAC) valve elect ...