Ford Mustang (1999-2004) Service Manual: Water Pump
Removal and Installation
1. Disconnect the battery ground cable.
2. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section.
3. Remove the retainer and position the inner fender well aside.
4. Disconnect the water pump electrical connector.
5. Disconnect the coolant hoses.
6. Remove the bolts and the water pump.
7. To install, reverse the removal procedure.
Supercharger Cooling System Flushing
1. WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling system is hot. Failure to follow these instructions can result in damage to the cooling system or e ...Radiator
Removal and Installation 1. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section. 2. NOTE: RH is shown LH is similar. D ...Other materials:
Component Tests
Grid Wire Test
1. Using a bright lamp inside the vehicle, inspect the wire grid from
the exterior. A broken grid wire
will appear as a brown spot.
2. Run the engine at idle. Set the rear window defrost switch to ON. The
indicator light should
co ...
Moulding - Roof Side
Removal and Installation
1. Remove the weatherstrip.
2. Remove the exterior roof side moulding screws.
3. Remove the interior roof side moulding screws.
4. Remove the roof side moulding screw.
5. Release the clips.
1. Lift up to release the two ...
Weld Nut Repair - Missing Weld Nut,
Restraints Control
Module (RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...