Ford Mustang (1999-2004) Service Manual: Water Pump - 4.6L(2V) and 4.6L(4V)
Material
Item | Specification |
Motorcraft Premium Gold Engine Coolant VC-7-A (in Oregon VC-7-B) (yellow color) | WSS-M97B51- A1 |
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensioner clockwise and remove the supercharger drive belt.
4. Remove the coolant hose mounting bolt.
5. Remove the belt idler bracket support assembly.
All vehicles
6. Drain the engine coolant. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section.
7. Loosen the coolant pump pulley bolts.
8. Remove the accessory drive belt. For additional information, refer to Section.
9. Remove the bolts and the coolant pump pulley.
10. Remove the four bolts and the coolant pump.
11. If necessary, wipe the coolant pump mounting surface with a soft cloth.
12. CAUTION: Do not rotate the coolant pump housing once installed in the engine.
Damage to the O-ring seal can occur, causing the coolant pump to leak.
NOTE: Install a new O-ring seal and lubricate with the same clean engine coolant that is present in the system. Do not mix coolant types.
To install, reverse the removal procedure.
Water Pump - 3.8L
Material Item Specification Motorcraft Premium Gold Engine Coolant VC-7-A (in Oregon VC-7-B) (yellow color) WSS-M97B51- A1 Removal and Installation 1. Drain the engine coola ...Radiator
Material Item Specification Motorcraft Premium Gold Engine Coolant VC-7-A (in Oregon VC-7-B) (yellow color) WSS-M97B51- A1 Removal and Installation NOTE: Radiator removal an ...Other materials:
General Maintenance Information
NOTE: This is a generic maintenance schedule for all Ford, Lincoln and
Mercury vehicles. There may
be items listed that do not apply to all vehicles.
The Normal Schedule applies to operation of the vehicle under typical, everyday
driving conditions.
The ma ...
Coupling
Removal and Installation
1. CAUTION: Do not allow the steering column shaft to rotate while
intermediate shaft
is disconnected or damage to the clockspring can result. If there is evidence
that the
steering column shaft has rotated the clockspring must be re ...
Rear Drive Halfshafts (Description and Operation)
The rear wheel drive halfshaft system consists of and operates as
follows:
Halfshafts (4K138) transmit engine torque from the rear axle housing to
the rear wheels.
Halfshafts rotate at approximately one-third the speed of a driveshaft
and do not cont ...