Ford Mustang (1999-2004) Service Manual: Wheel Hub and Bearing

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure correct retention of these parts.

1. Raise the vehicle on a hoist.

2. Remove the wheel and tire assembly.

3. Remove the front brake disc.

4. Remove and discard the front hub cap grease seal (1N135).

Wheel Hub and Bearing

5. CAUTION: The wheel hub retainer (3B477) is a one time use item and must be replaced with a new retainer when removed. Failure to do so can cause the retainer to come loose during vehicle operation resulting in loss of vehicle control.

Remove and discard the front axle wheel hub retainer.

Wheel Hub and Bearing

6. Remove the front wheel hub and bearing (1104).

Wheel Hub and Bearing

Installation

1. NOTE: Use a new wheel hub retainer and hub cap grease seal.

To install, reverse the removal procedure.

Wheel Hub and Bearing

    Wheel Studs
    Removal 1. Remove the wheel hub (1104). For additional information, refer to Wheel Hub and Bearing in this section. 2. Using a press, remove the wheel stud (1107) from the wheel hub. Installation 1 ...

    Arm - Lower
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

    Other materials:

    Air Cleaner Outlet Pipe - 3.8L
    Removal and Installation 1. Remove the air cleaner outlet tube. 1. Loosen the clamps. 2. Disconnect the hose. 3. Remove the tube. 2. To install, reverse the removal procedure. Air Cleaner Outlet Pipe -4.6L (2V) Removal and Installation 1. Dis ...

    Principles of Operation
    There are four main principles involved with the basic theory of operation: heat transfer latent heat of vaporization relative humidity effects of pressure Heat Transfer If two substances of different temperature are placed near each other, t ...

    Reactivation Procedure
    1. WARNING: The restraint system diagnostic tool must be removed and the air bag modules reconnected when the system is reactivated to avoid non-deployment in a collision, resulting in possible personal injury. WARNING: The restraint system diagnostic tool i ...