Ford Mustang (1999-2004) Service Manual: Wheel Studs

Special Tool(s)

 C-Frame and Clamp Assembly 211-023 (T74P-3044-A1)

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Raise the vehicle on a hoist.

2. Remove the wheel and tire assembly.

3. Remove the rear brake disc.

4. Using the special tool, remove and discard the wheel stud.

Wheel Studs

Installation

CAUTION: Do not use air tools to install the wheel stud. The serrations in the hub flange can be stripped.

1. Install the wheel stud.

1. Position a new wheel stud in the hub flange making sure the serrations on the stud line up with the serrations in the flange.

2. Position washers and a reversed wheel nut on the wheel stud.

3. Tighten the wheel nut until the wheel stud seats on the back of the hub flange.

Wheel Studs

2. Remove the wheel nut and washers. Discard the nut.

3. Install the rear brake disc.

4. Install the wheel and tire assembly.

5. Lower the vehicle.

    Installation
    1. Install the bearing. 1. Position the knuckle on the press. 2. Using the appropriate step plate adapter, press the bearing into the knuckle until the bearing clears the snap ring groove and b ...

    Upper Arm
    ...

    Other materials:

    Camber Adjustment - Rear
    1. Loosen the nut. 2. Rotate the bolt and the cam to the correct camber setting. 3. Tighten the nut while holding the bolt and the cam stationary. 4. Recheck the wheel alignment. Follow the manufacturer's instructions. Adjust as necessary. ...

    Sitting in the correct position
    WARNING: Sitting improperly out of position or with the seat back reclined too far can take off weight from the seat cushion and affect the decision of the passenger sensing system, resulting in serious injury or death in a crash. Always sit upright against yo ...

    Fuel Vapor Control Tube Assembly Valve
    Removal and Installation 1. Remove the fuel tank. For additional information, refer to Section. 2. Remove the retainers. 3. NOTE: The fuel vapor vent valve, fuel vapor control valve and the in-line fuel tank pressure sensor are repaired as a fuel va ...