Ford Mustang (1999-2004) Service Manual: Wiper Blade and Pivot Arm Adjustment
1. Cycle and park the windshield wipers.
2. Verify that the distance between the center of the RH windshield wiper blade and the top edge of the cowl top vent panel is within specification.
3. Verify that the distance between the center of the LH windshield wiper blade and the top edge of the cowl top vent panel is within specification.
4. If the distance is not within specification, remove the windshield wiper pivot arms and reposition to specification.
Remove the pivot arm.
1. Pull up on the pivot arm.
2. Pull out on the retainer tab and remove the pivot arm.
Pivot Arm
Removal
1. NOTE: New windshield wiper pivot arms need to be installed as an assembly.
Remove the pivot arm.
1. Pull up on the pivot arm.
2. Pull out on the retainer tab and remove the pivot arm.
Installation
1. To install, reverse the removal procedure.
Component Test
Windshield Wiper Motor CAUTION: Do not handle the wiper motor abusively when diagnosing the wiper operations. Failure to follow this caution may result in damage to the motor magnets and wil ...Mounting Arm and Pivot Shaft
Removal 1. Park the windshield wipers in the full upright position. This will allow for easy access to the retaining clip on the wiper motor output shaft. 2. Remove the cowl top vent panels. ...Other materials:
Resistor
Removal
1. Disconnect the connector.
2. Remove the screws.
3. Remove the resistor.
Installation
1. To install, reverse the removal procedure. ...
Pinpoint Tests - OSC Equipped Vehicles
Special Tool(s)
Breakout Box, EEC-V Control
System
418-049 (T94L-50-EEC-V) or
equivalent
MLP-TR Cable
418-F107 (007-00111) or
equivalent
Worldwide Diagnostic System
(WDS)
418-F224
New Generation STAR (NGS)
T ...
Clutch Pedal Position (CPP) Switch
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Disconnect the connector.
3. Remove the bolt and the clutch pedal position (CPP) switch.
Installation
1. To install, reverse the removal procedure. ...