Ford Mustang (1999-2004) Service Manual: Brake Caliper Anchor Plate
Removal
1. Remove the pads. For additional information, refer to Pads in this section.
2. Remove the anchor plate (2B292).
1. Remove and discard the anchor plate bolts.
2. Remove the anchor plate.
Installation
1. CAUTION: Use correct type and length bolts.
Follow the removal procedure in reverse order.
- Install new anchor plate bolts.
Brake Caliper Anchor Plate - Cobra
Removal
1. Remove the pads. For additional information, refer to Brake
Pads-Cobra in this section.
2. Remove the anchor plate bolts.
Installation
1. Follow the removal procedure in reverse ...
Disc
Removal
1. Remove the front disc brake caliper anchor plate (2B292). For
additional information, refer to
Brake Caliper Anchor Plate in this section.
2. Match mark the hub (1104) and the bra ...
Other materials:
Pinpoint Test F: LFC 16/DTC B1888 - Passenger Air Bag Circuit Shorted to
Ground
Normal Operation
The restraints control module (RCM) checks for passenger air bag circuit
shorts to ground by
monitoring the voltage of circuits 607 (LB/OG) and 616 (PK/BK) at pins 6 and
7. If the RCM detects a
short to ground on either of these pins, i ...
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information
refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure. ...
Disassembly
1. NOTE: Mark the position of each gear shifter fork (7230).
Place the gear shift plates (7N232) and the gear selector interlock sleeve
(7K201) in the neutral
position to center the gear shift plates and the selector body (7302).
2. Rotate the main shif ...
