Ford Mustang (1999-2004) Service Manual: Bulb

Removal and Installation

1. Remove the floor console. For additional information, refer to Section.

2. Remove the bolts, then position the bezel upward.

Bulb

3. Remove the bulb socket from the bezel.

Bulb

4. Remove the bulb.

Bulb

5. To install, reverse the removal procedure.

Bulb

    Bezel
    Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the connector. 6. CAUTION ...

    Knob
    Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the TCS connector. 6. CAU ...

    Other materials:

    Disc and Pressure Plate - 4.6L (4V) Engine
    Special Tool(s) Clutch Aligner 308-020 (T74P-7137-K) Material Item Specification Premium Long Life Grease XG-1-C ESA-M1C75-B 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove t ...

    Flywheel Ring Gear
    Removal 1. Remove the flywheel. 2. WARNING: This procedure should be carried out only by a correctly equipped and experienced acetylene torch operator. Tongs must be used or asbestos gloves worn when handling the heated flywheel ring gear. Failure to f ...

    Pinpoint Tests
    PINPOINT TEST A: THE SPEED CONTROL IS INOPERATIVE Test Step Result / Action to Take A1 CHECK THE SPEED CONTROL SERVO VOLTAGE AND GROUND YesGO to A3 . No GO to A2 . Key in OFF position. Disconnect: Speed Control Servo C122. ...