Ford Mustang (1999-2004) Service Manual: Knob

Removal

1. Remove the shifter top control panel.

Knob

2. Disconnect the electrical connectors.

Knob

3. Remove the shifter bezel.

Knob

4. Remove the bulb from the bezel.

Knob

5. Disconnect the TCS connector.

Knob

6. CAUTION: Extra force may be needed to lift up on the handle. Do not to pull too far or damage to the overdrive cancel button may result, as the wires may be pulled out of the switch.

Remove the screw and the handle.

Knob

7. Remove the transmission control switch.

Knob

Installation

1. To install, reverse the removal procedure.

 

    Bulb
    Removal and Installation 1. Remove the floor console. For additional information, refer to Section. 2. Remove the bolts, then position the bezel upward. 3. Remove the bulb socket from the bez ...

    Other materials:

    Fittings - Vapor Tube
    Disconnect 1. WARNING: The evaporative emission system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents the danger of explosion or fire. Disconnect the battery ground cable from the battery to minimiz ...

    Exterior Trim and Ornamentation
    Torque Specifications Exterior Trim and Ornamentation The exterior trim and ornamentation consists of the following components: body side scoop hood scoop (if equipped) front spoiler (Mach 1) radiator grille rear spoiler (if equipped) ...

    Water Bypass Hose - 3.8L
    Removal and Installation 1. Drain the engine coolant. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section. 2. Remove the bypass hose. 3. To install, reverse the removal procedure. 4. Fill and bleed the co ...