Ford Mustang (1999-2004) Service Manual: Cable Adjustment

1. NOTE: Make sure that the range selector lever is tight against the rearward overdrive stop.

Place the transmission range selector lever in the overdrive position.

2. Raise and support the vehicle. For additional information, refer to Section.

3. Loosen the manual control lever nut.

Cable Adjustment

4. Place the transmission manual control lever in the overdrive position.

5. Tighten the nut on the manual control lever.

Cable Adjustment

    External Controls (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 37 , Shift Lock for schematic and connector information. Refer to Wiring Diagrams Cell 29 , Transmission Control for schematic and connector information. Special Tool(s ...

    Brake Shift Interlock Actuator
    Removal 1. Remove the shifter top control panel. 2. Disconnect the electrical connectors. 3. Remove the shifter bezel. 4. Remove the bulb from the bezel. 5. Disconnect the electrical connect ...

    Other materials:

    Drive Pinion Flange and Drive Pinion Seal
    Special Tool(s) 2-Jaw Puller 205-D072 (D97L-4221-A) or equivalent Holding Fixture, Drive Pinion Flange 205-126 (T78P-4851-A) Installer, Drive Pinion Flange 205-002 (TOOL-4858-E) or equivalent ...

    Camshaft End Play - Push Rod Engines
    Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent 1. Remove the valve tappets. Refer to the appropriate section in Group 303 for the procedure. 2. Use a Dial Indicator Gauge with Holding Fixture ...

    Accelerator Cable - 4.6L (2V)
    Removal and Installation 1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm. 2. Remove the bolts retaining the accelerator cable to the dash panel. 3. Disconnect the accelerator cable from the throttle body by rotating ...