Ford Mustang (1999-2004) Service Manual: Daytime Running Lamps
Torque Specifications
Daytime Running Lamps (DRL)
The daytime running lamp (DRL) system consists of a daytime running lamp module and bracket assembly (15A270). The module is located on the front bumper reinforcement.
Lamp Assembly - Map/Dome
Removal
1. Disconnect the battery ground cable.
2. Remove the lamp lens from the lamp assembly.
3. Remove the lamp assembly.
1. Remove the screws.
2. Remove the lamp assembly.
Discon ...
Daytime Running Lamps (DRL) (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 97 , Daytime Running Lamps for schematic
and connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Principles of Oper ...
Other materials:
Assembly
1. Lubricate all components with the recommended transmission fluid when
reassembling.
2. Using the special tools, press the output shaft front bearing on the output
shaft.
3. Install the third gear bearing.
Apply petroleum jelly to the bearing.
4. I ...
Installation
Lift cylinder
1. NOTE: Be sure that each fitting is installed in the correct position on
the folding top hydraulic
component.
NOTE: Make sure that the tetra seal is installed in the bottom of each of the
folding top
hydraulic cylinder ports before attaching ...
Engine - 4.6L (2V)
General Specifications
a - With installation of a new filter.
b - Distance front edge of bearing is installed below front face of cylinder
block.
c - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force
and leak down fluid in
tap ...
