Ford Mustang (1999-2004) Service Manual: Engine Mount RH
Special Tool(s)
 |
Lifting Bracket, Engine 303-D088 (D93P-6001-A2) |
 |
Support Bar, Engine 303-290-A |
Removal
1. Install the special tool.
2. Install the special tools.
3. Remove the starter. For additional information, refer to Section.
4. Remove the two engine mount nuts.
5. Lower the vehicle.
6. Using the special tools, raise the engine.
7. Raise and support the vehicle. For additional information, refer to Section.
8. Remove the engine mount.
Installation
1. To install, reverse the removal procedure.
Engine Mount LH
Special Tool(s)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Support Bar, Engine
303-290-A
Removal
1. Install the special tool.
2. Install the special tools.
3. Ra ...
Other materials:
Retractor - Front Seat Safety Belt, Coupe
Special Tool(s)
Torx Bit, Safety Belt Bolt
501-010 (T77L-2100-A)
Removal
1. Remove the quarter trim panel (31012). For additional information, refer
to Section.
2. Using the special tool, remove the bolt and the safety belt retractor.
Remov ...
Removal
1. Remove the roller followers. For additional information, refer to Roller
Followers in this section.
2. Remove the LH timing chain for the LH side and both timing chains for the RH
side. For
additional information, refer to Timing Drive Components in this ...
Switch - Deactivator
Removal
1. Disconnect the battery ground cable.
2. Remove the deactivator switch.
1. Disconnect the deactivator switch electrical connector.
2. Detach the lower deactivator switch hook.
3. Detach the upper deactivator pivot.
Installation
1. N ...
