Ford Mustang Service Manual: Normal Schedule
General Maintenance Information
NOTE: This is a generic maintenance schedule for all Ford, Lincoln and Mercury vehicles. There may be items listed that do not apply to all vehicles.
The Normal Schedule applies to operation of the vehicle under typical, everyday driving conditions.
The maintenance frequency in this schedule typifies what the vast majority of vehicles will require. The listed services should be carried out at specified mileage intervals. There are, however, additional services required that only the noted vehicles require.
If the vehicle is operated in one or more of the following special operating conditions, those additional services will be required. The special operating conditions are:
- towing or carrying heavy loads.
- extensive idling and/or driving at low speeds for long distances.
- driving in dusty conditions.
- off-road operation.
There are also exceptions to the Normal Operating Schedule which will require more frequent maintenance for some components. Those exceptions are:
- natural gas and propane vehicles - fuel tank intervals.
- normal vehicle axle - maintenance and lubrication.
- police and taxi vehicles - maintenance and lubrication.
- engine oil and yellow coolant - time and mileage-based interval.
Checks and Services
General Maintenance Information NOTE: This is a generic maintenance schedule for all Ford, Lincoln and Mercury vehicles. There may be items listed that do not apply to all vehicles. The Normal Sched ...Exceptions To Normal Schedule
General Maintenance Information NOTE: This is a generic maintenance schedule for all Ford, Lincoln and Mercury vehicles. There may be items listed that do not apply to all vehicles. The Normal Sched ...Other materials:
Engine Ignition (Description and Operation)
Engine Ignition (Description and Operation)
The ignition coil (12029), which is mounted on the upper intake manifold, can
be described as a coil
pack containing three separate coil units. Each coil unit is individually
controlled by the powertrain
control mo ...
Component Test
Principles of Operation
Multifunction Wipers
The front wiper/washer feature controls the speed of the front
windshield wipers and the amount of
washer fluid sprayed on the front windshield when requested by the
customer. There are five (5) wiper
...
Link - Stabilizer Bar
Wheel Studs
Removal
1. Remove the wheel hub (1104). For additional information, refer to Wheel
Hub and Bearing in
this section.
2. Using a press, remove the wheel stud (1107) from the wheel hub.
Installation
1. Using a press, install a new wheel stud.
2. I ...