Ford Mustang (2005-2014) Owners Manual: Ordering additional owner’s literature

To order the publications in this portfolio, contact Helm, Incorporated at:

HELM, INCORPORATED
47911 Halyard Drive
Plymouth, Michigan 48170
Attention: Customer Service
Or to order a free publication catalog, call toll free: 1-800-782-4356
Monday-Friday 8:00 a.m. - 6:00 p.m. EST
Helm, Incorporated can also be reached by their website:
www.helminc.com.

(Items in this catalog may be purchased by credit card, check or money order.)

Obtaining a French Owner’s Manual

A French owner’s manual can be obtained from your authorized dealer or by contacting Helm, Incorporated using the contact information listed previously in this section.

    Getting assistance outside the U.S. And Canada
    Before exporting your vehicle to a foreign country, contact the appropriate foreign embassy or consulate. These officials can inform you of local vehicle registration regulations and where to find unl ...

    Reporting safety defects (U.S. only)
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in add ...

    Other materials:

    Instrument lighting dimmer
    • Move the control up or down to adjust the intensity of the panel lighting. • Move the control to the full upright position, past detent, to turn on the interior lamps. • Move the control down, past detent, to turn off the interior lights. Note: The pa ...

    Brake Caliper - Cobra
    Removal 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. Remove the caliper locating pin E-clip. 4. Remove the caliper locating pin. 5. Remove the front brake flow bolt. 6. Remove the caliper. 7. Remove the brake pa ...

    Cylinder Head - Distortion
    Special Tool(s) Straight Edge 303-D039 (D83L-4201-A) or equivalent 1. Use a straight edge and a feeler gauge to inspect the cylinder head for flatness. If the cylinder head is distorted, install a new cylinder head. Cylinder Bore -Cleaning ...