Ford Mustang Service Manual: Pads

Front Disc Brake (

Description and Operation)

Front Disc Brake Components

 


 

Disc Brake Caliper Components


Disc Brake Caliper Components

 


 

The front disc brake caliper (2B120):


The front disc brake caliper (2B120):

  • bolts to the front disc brake caliper anchor plate (2B292), which bolts to the front wheel spindle (3105).
  • is a pin slider, dual piston design.

The front brake discs (1125):

  • are of a ventilated full-cast design, with non-directional cooling fins.
  • are serviced with the disc brake caliper and front disc brake caliper anchor plate removed.

The front brake disc shield (2K005):

  • is riveted to the front wheel spindle.
  • protects the front wheel bearings and inboard surface of the front brake disc.

The pads:

  • are housed in the front disc brake caliper anchor plate.
  • are of a non-asbestos, non-metallic composition.
Front Disc Brake (Description and Operation)
Front Disc Brake (Description and Operation) Front Disc Brake Components   Disc Brake Caliper Components   The front disc brake caliper (2B120): bolts to the front disc brake c ...

Removal
Removal 1. Remove brake master cylinder filler cap (2162). Check brake fluid level in brake master cylinder reservoir (2K478). Remove fluid until brake master cylinder reservoir is half full ...

Other materials:

Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
General Specifications a: In-vehicle repair refill capacities are determined by filling the rear axle with the specified lubricant to 6.4-14.3-mm (1/4-9/16-in) below the bottom of the fill hole. Torque Specifications ...

Reactivation Procedure
Deactivation Procedure WARNING: If the supplemental restraint system (SRS) is being serviced, the system must be deactivated and restraint system diagnostic tools must be installed. Refer to Air Bag Supplemental Restraint System (SRS) in this section. The a ...

Actuator - Door Lock
Handles, Locks, Latches And Mechanisms (Description and Operation) Lock Cylinders Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock r ...