Ford Mustang (1999-2004) Service Manual: Pads

Caliper (Removal and Installation)

Special Tool(s) Rear Caliper Piston Adjuster 206-026 (T87P-2588-A) Removal 1. Raise the vehicle on a hoist. 2. Remove the wheel and tire assembly. 3. Disengage the parking br ...

Removal

1. Use a suitable suction device to lower the brake fluid level in the master cylinder reservoir. 2. Raise and support the vehicle. 3. Remove the wheel and tire assembly. 4. Inspec ...

Other materials:

Retractor - Rear Seat Safety Belt, Coupe
Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section. 2. Using the special tool, remove the D-ring bolt. 3. U ...

Generator - 3.8L
Removal and Installation 1. Disconnect the battery (10655). For additional information, refer to Section. 2. Relieve the accessory drive belt (8620) tension and remove the belt from the generator pulley. Leave the belt in place for reinstallation ...

Inspection and Verification
1. The keyless entry system is a generic electronic module (GEM). 2. Verify the customer concern by using the remote transmitters to operate the keyless entry system. 3. Visually inspect for the following obvious signs of mechanical and electrica ...