Ford Mustang (1999-2004) Service Manual: Push Rod

Removal

CAUTION: Mark the components removed for correct location.

1. Remove the rocker arms (6564). For additional information, refer to Rocker Arm in this section.

2. Remove the push rods (6565).

Push Rod

3. Inspect the components. For additional information, refer to Section.

Installation

1. To install, reverse the removal procedure.

    Rocker Arm
    Removal CAUTION: If removing more than one rocker arm (6564), mark the components removed for correct location. 1. Remove the valve covers. For additional information, refer to Valve Cover-LH ...

    Valve Springs
    Special Tool(s) Compressor, Valve Spring 303-163 (T81P-6513-A) Material Removal 1. Remove the LH and the RH valve covers. For additional information, refer to Valve Cover-LH and V ...

    Other materials:

    Battery Cables
    Removal WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When charging or working near a battery, always shield your face an ...

    Engine coolant check
    Checking the Engine Coolant The concentration and level of engine coolant should be checked at the intervals listed in Scheduled Maintenance Information. Note: Make sure that the level is at the FULL COLD level or within the COLD FILL RANGE in the coolant res ...

    Installation
    1. Apply silicone gasket and sealant in the locations shown. 2. Install the engine front cover.   3. Install the belt idler pulleys and the bolts. 4. Connect the CMP sensor electrical connector. 5. Raise the vehicle. 6. Install the crankshaft fr ...