Ford Mustang (1999-2004) Service Manual: Rear Bumper Cover

Removal and Installation

1. Remove the luggage compartment trim panel covers.

2. Remove the seven rear bumper cover nuts.

Rear Bumper Cover

3. Remove the fuel drain hose.

Rear Bumper Cover

4. Remove the four bumper cover screws (two each side).

Rear Bumper Cover

5. Remove the pin-type retainers and the rear bumper cover.

Rear Bumper Cover

6. To install, reverse the removal procedure.

    Front Bumper Cover
    Removal and Installation NOTE: Mustang shown, GT and Cobra similar. 1. Remove the pin-type retainers and the radiator upper sight shield. 2. Remove the two pin-type retainers (one each side). 3. R ...

    Front Bumper
    Special Tool(s) Heavy-Duty Riveter 501-D011 (D80L-23200-A) Removal and Installation All vehicles except Cobra 1. Remove the front bumper cover. For additional information, refer to Fro ...

    Other materials:

    Driveline System
    Special Tool(s) Clamp Plate 205-320 (T92L-4851-C) Clutch Housing Alignment Adapter 308-021 (T75L-4201-A) Companion Flange Holding Tool 205-126 (T78P-4851-A) Companion Flange Runout Gauge 205-319 (T92 ...

    Interior Lighting (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 111 , Remote Control Alarm and Lock System for schematic and connector information. Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for schematic and connector information. Refer to Wiring Diagrams Cell 89 , ...

    Engine - Mach I 4.6L (4V)
    General Specifications Engine Specifications a - Newly Installed-Refers to the condition of the "NEW" drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pu ...