Ford Mustang (1999-2004) Service Manual: Hydraulic Control Unit

Removal

1. Disconnect the battery ground cable(14301).

2. Disconnect the anti-lock-brake control module electrical connector.

Hydraulic Control Unit

3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction control is shown , the 4WABS without traction control system is similar with one less hydraulic line.

NOTE: Plug brake lines to prevent any brake fluid loss.

Disconnect the brake lines from the hydraulic control unit (HCU).

Hydraulic Control Unit

4. Remove the HCU bracket nuts to HCU.

Hydraulic Control Unit

5. Remove the HCU.

Hydraulic Control Unit

6. Remove the pump motor electrical connector.

Hydraulic Control Unit

7. Remove the anti-lock-brake control module screws.

Hydraulic Control Unit

8. Remove the anti-lock-brake control module from the HCU.

Installation

1. NOTE: The brake system must be bled after the HCU is installed or replaced. To install, reverse the removal procedure.

Hydraulic Control Unit

 

Hydraulic Control Unit

    Sensor Indicator - Rear
    Special Tool(s) Pinion Bearing Cone Remover 205-D002 (D79P-4621A) Axle Bearing/Seal Plate 205-090 (T75L-1165-B) Sensing Ring Replacer 206-041 (T89P-20202-A) Removal ...

    Module
    Removal 1. Remove the hydraulic control unit (HCU). Refer to Hydraulic Control Unit . 2. Remove the pump motor electrical connector. 3. Remove the anti-lock-brake control module screws. 4. Remove th ...

    Other materials:

    Suction Accumulator
      NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator. In addition to th ...

    Canister Vent Solenoid Closing Procedure
    Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool CAUTION: The canister vent solenoid must not be energized for more than nine minutes at one time. Once the ...

    Disassembly
    1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate serrations for scores or burrs. Minor scores or burrs may be removed with a crocus cloth. Install a new clutch cylinder if badly scored or damaged. 2. Check fluid passage in the cl ...