Ford Mustang (2005-2014) Owners Manual: Transmission code designation
You can find a transmission code on the Safety Compliance Certification Label. The following table tells you which transmission each code represents.
Vehicle certification label
The National Highway Traffic Safety
Administration Regulations require
that a Safety Compliance Certification
Label be affixed to a vehicle and
prescribe where the Safety Compliance
Certification Lab ...
Accessories
For a complete listing of the accessories that are available for your
vehicle, please contact an authorized dealer or visit our online store at
Accessories.Ford.com (United States only).
Ford Custom ...
Other materials:
Engine - 3.8L
General Specifications
a - 20-200 seconds to leakdown 3.18 mm (0.125 in) with 225 Newtons (50
pounds) load and tappet filled
with leak-down fluid.
Torque Specifications
a - Refer to the procedure in this section
b - Advance one-half turn aft ...
Fuel Pump Module
Removal and Installation
1. Remove the fuel tank. For additional information, refer to Fuel Tank in
this section.
2. NOTE: For installation, tighten the bolts in the sequence shown.
Remove the module assembly flange bolts.
3. Clean the area around the fue ...
Master Cylinder
Removal
1. Disconnect the fluid level sensor connector.
2. Disconnect the brake tubes.
3. Remove the brake master cylinder nuts.
4. Remove the brake master cylinder (2140).
Installation
1. To install, reverse the removal procedure.
Bleed the brake ...
