Ford Mustang (1999-2004) Service Manual: Bleeding - Components
Special Tool(s)
Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool | |
NGS Flash Cable 418-F120 (007-00531) or Equivalent |
- Master Cylinder Priming - In-Vehicle or Bench
- Master Cylinder Priming - 4.6L
- Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
- Caliper
Component Tests
Brake Booster 1. Check the hydraulic brake system for leaks or insufficient fluid. 2. With the transmission (7003) in NEUTRAL, stop the engine (6007) and apply the parking brake control (278 ...Master Cylinder Priming - In-Vehicle or Bench
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 min ...Other materials:
Assembly
1. Install the locking lever cam and pin.
2. Install the lock actuator lever and pin.
3. Install the lock actuator lever return spring.
4. Install the ignition lock cylinder lockout lever.
5. NOTE: The lock lever with two teeth is installed on the left ...
Cooling Fan Motor and Shroud
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the degas bottle or coolant expansion tank. For additional
information, refer to Degas
Bottle-4.6L(2V) and 4.6L(4V) in this section.
3. Disconnect the cooling fan electrical connecto ...
Transmission (Disassembly)
Special Tool(s)
Holding Fixture, Transmission
307-003 (T57L-500-B)
Puller, Bearing
205-D064 (D84L-1123-A)
2 or 3 Jaw Puller
205-D027 (D80L-1013-A)
Remover, Mainshaft Bearing
308-058 (T77J-7025-H)
...