Ford Mustang (1999-2004) Service Manual: Fill

1. WARNING: Do not mix oil types, any mixture or any unapproved oil can lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

2. Remove the fuel pump fuse from the battery junction box.

3. Raise the front wheels off the floor.

4. CAUTION: Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature starter failure can occur.

CAUTION: Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump will occur.

Turn the steering wheel from stop-to-stop while cranking the engine.

5. Lower the vehicle.

6. CAUTION: Do not overfill the reservoir.

Check the fluid level. If necessary, fill the reservoir to the correct level.

  • Use Motorcraft MERCON Multi-Purpose ATF XT-2-QDX or MERCON equivalent.

7. Install the fuel pump fuse.

 

    Purging - CIII Power Steering Pump
    Special Tool(s) Vacuum Pump 416-D002 (D95L-7559-A) or Equivalent CAUTION: If the air is not purged from the power steering system correctly, premature power steering pump failure ca ...

    Power Steering
    General Specifications Torque Specifications a - Once torque is reached, continue turning to align slot in nut with cotter pin hole in tie-rod. ...

    Other materials:

    Wheel Leaks
    Material Item Specification Professional Choke and Linkage Cleaner F8AZ-19520-AB WSS-M14P10- B Aluminum Wheel Repair Compound ESA-M4G280- A WARNING: Wheel repairs that use welding or peening are not approved. An inner tube ...

    Removal
    CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. ...

    Ignition Switch Lock Cylinder - Functional
    Removal and Installation 1. Disconnect the battery ground cable. 2. Remove the ignition switch lock cylinder (11582). 1. Insert the ignition key and turn to the RUN position. 2. Using a 1/8-inch drift, press the ignition switch lock cylinder release ...